Messages On The Front Panel Display - Yamaha CRX-N560 Bedienungsanleitung

Troubleshooting

Messages on the front panel display

Message
There is a problem with the signal path from your iPod to this unit.
The iPod/USB device being connected is not supported by the unit.
Unknown
The iPod software is out of date.
Timer not work The unit is in the eco standby mode.
The connected iPod/USB device is not supported by the unit.
Overcurrent
iPod/USB device is not connected properly.
Unplugged iPod/USB device is not connected firmly.
The disc set in the unit may not be supported by the unit.
No Disc The disc may be dirty, or foreign objects may be attached to it.
Disc is set upside-down.
No Songs The disc does not contain playable files.
Initializing The unit is starting up.
Loading... The unit is loading the specified file/contents.
No Content Selected folder does not contain playable files.
Not Connected The unit is not connected to the Internet.
Unsupported You are trying to play back a file which the unit does not support
No Operation You are trying to open the disc tray while setting the option menu.
Access Denied Access to the PC is denied.
The unit cannot access the USB device.
The unit cannot access the iPod.
Access Error
The connected iPod is not supported by the unit.
There is a problem with the signal path from the network to the unit.
Version Error Firmware update is failed.
42
En
Cause Solution
Reconnect the iPod.
Use a supported iPod/USB device ( P.43).
Download the latest iTunes software from Apple's website to update the iPod software
version.
Set [Power Saving] to [Normal] with the option setting (
Disconnect the iPod/USB device, turn off the unit, and turn it on again. If this does not
solve the problem for the USB device, it is not playable on the unit.
Disconnect the iPod/USB device and reconnect it (
Use a disc supported by the unit ( P.43).
Remove the disc and then wipe the disc clean.
Set the disc with the labeled side facing up.
Set a disc with playable files ( P.43).
Wait until the message disappears. If the message stays more than 3 minutes, turn off the
unit and turn it on again.
Wait until the unit finishes loading.
Select a folder with playable files ( P.44).
Check the Internet connection.
Play a file supported by the unit ( P.44).
Open the disc tray after the option setting is finished.
Configure the sharing settings and select the unit as a device to which music contents are
shared ( P.17).
Turn off the unit and reconnect your USB device. If the problem persists, try another USB
device.
Turn off the iPod and turn it on again.
Use an iPod supported by the unit ( P.43).
Make sure your router and modem are turned on.
Check the connection between the unit and your router (or hub) (
Update the firmware again.
P.12).
P.15).
P.11).