Care And Maintenance; Troubleshooting Guide - Cocraft PRO A850-M Bedienungsanleitung

Note: Always keep your thumb close to the power switch so you can switch
the power tool off quickly if necessary.
Note: If the power supply to the angle grinder is interrupted (e.g. by a power cut) when
the power switch is set to ON, the angle grinder will not restart automatically when
the power is restored. You will need to press down the rear of the power switch and
let the spring return it to its original position before the angle grinder can be started
again. This is a safety feature to prevent the angle grinder from starting unintentionally.

Care and maintenance

• Always unplug the mains lead from the wall socket before cleaning or maintenance
of any sort.
• Keep the motor ventilation openings (3) free from contaminants.
• Clean the angle grinder using a lightly moistened cloth. Use only mild cleaning
agents, never solvents or corrosive chemicals.
• If the mains lead is damaged it should only be replaced by a qualified electrician.
• If the angle grinder is not to be used for an extended period, it should be
unplugged and stored in a dry and dust-free location out of reach of children.

Troubleshooting guide

The angle grinder
will not switch on.
The angle grinder
runs slowly.
Heavy vibrations.
Responsible disposal
This symbol indicates that this product should not be disposed of
with general household waste. This applies throughout the entire EU.
In order to prevent any harm to the environment or health hazards
caused by incorrect waste disposal, the product must be handed in
for recycling so that the material can be disposed of in a responsible
manner. When recycling your product, take it to your local collection
facility or contact the place of purchase. They will ensure that
the product is disposed of in an environmentally sound manner.
• Make sure that the mains lead is undamaged and securely
plugged into a wall socket.
• Make sure that the wall socket is live.
• Remember not to press against the workpiece too hard.
• Wheel/disc damaged or out of balance. Check the alignment
and refit accessory. Replace the damaged accessory.
13