Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8. Adjust the spark deflector (2) and tool rest (5) to max 2 mm from the grinding
wheel and tighten.
9. Make sure that the grinding wheel can rotate freely before starting the machine.
10. Stand to the side of the machine. Start it and let it get up to speed to make sure
the wheel is balanced before grinding.
Note:
•
Do not remove the cardboard discs attached to the sides of the new grinding
wheel because they aid the secure grip of the flange against the grinding wheel.
•
Check the new grinding wheel for cracks or other visible damage before fitting.
Never use a damaged grinding wheel.
•
Do not tighten the nut too much with a spanner because the grinding wheel may
break.
Changing the wet grinding wheel
1. Set the power switch to 0 and
unplug the grinder from the wall
socket before changing the grinding
wheel.
2. Drain the water from the container (11).
Loosen the 3 nuts and bolts (2 at
the top and 1 at the bottom) holding
the water container. The nuts and
bolts don't need to be removed,
just loosened. Push the container
towards the grinding wheel and
then downwards to remove it.
3. Important: Hold the wet grinding
wheel to prevent any load from
being exerted on the gearbox when
the retaining nut and flange are
removed from the spindle.
4. Remove the old wet grinding wheel and attach the new one.
5. Assemble in reversed order.
6. Stand to the side of the machine. Start it and let it get up to speed to make sure
the wheel is balanced before grinding.
Care and maintenance
•
Unplug the mains lead before cleaning the product.
•
Clean the product using a soft, moist cloth. Use a mild detergent.
Never use solvents or strong, abrasive cleaning agents.
11
10
10
10
Werbung
Inhaltsverzeichnis
