Axio Observer materials Bedienungsanleitung Seite 7

Axio Observer materials
Keep hands out of the path of the motorized X/Y scanning stages when these are being moved
or positioned.
Do not dispose of defective instruments in regular domestic waste; these should be disposed of
in accordance with the prevailing legal requirements.
Specimens should also be disposed of in compliance with the prevailing legal requirements and
internal operating procedures.
Axio Observer and its original accessories are to be used for the microscopy procedures
described in these safety instructions only. The manufacturer cannot assume any liability for any
other applications of the instrument, including the use of individual modules or components.
Modifications and repairs to this instrument and any devices operated in combination with the
Axio Observer are to be carried out by our service department or by authorized personnel only.
The manufacturer accepts no liability for damage caused by unauthorized access to the interior
of the instrument. Failure to comply with this shall also render all warranty claims invalid.
The Axio Observer microscopes 3 materials and 5 materials are equipped with a power supply
unit integrated in the stand allowing line voltages to be used in the ranges 100 to 127 V and
200 to 240 V AC ±10 %, 50/60 Hz, without the voltage setting on the instrument having to be
changed.
Voltage is supplied to the Axio Observer 7 materials by the external VP232-2 power supply unit
that belongs to the stand. This is designed for use in the ranges 100 to 240 V ±10 %, 50/60
Hz, without the voltage setting on the instrument having to be changed.
The ballast units for the HBO 100 (ebqb 100-04-z) and XBO 75 (ebx 75-04-z) and HXP 120 are
designed for use in the range from 100 to 240 V AC, 50 – 60 Hz. The devices automatically
adapt to the mains voltage.
Do not install the device close to heat sources such as radiators, or in direct sunlight. Broad
temperature fluctuations and vibrations should be avoided.
The power plugs may only be connected to sockets with earth contact. The protective capacity
must not be rendered ineffective by the use of extension cables with no grounding conductor.
Do not replace detachable power cables with power cables that do not meet the specifications.
Only the specified power cables should be used.
Before connecting the power cable, ensure that the mains voltage matches that on the type
plate of the Axio Observer.
09/2015
SAFETY INSTRUCTIONS
431004-8044-010
ZEISS
5