Axio Observer materials Bedienungsanleitung Seite 6

ZEISS
If there are reflector modules in the reflector turret which are fitted with neutral beam splitters
or partial mirrors in the beam-splitting mirror position or if these are fitted in the reflector turret
itself, looking into the eyepiece can cause injury to the eye if an HBO, X-Cite or HXP lamp is
switched on. This applies particularly if the specimen or the specimen holder has reflective
properties. Appropriate radiation attenuation measures must be taken (e.g. the use of neutral
filters) to prevent damage to the eyes.
When using fluorescence filters, the heat protection filter, which provides protection from
radiant heat emitted by the microscope illuminator, must not be removed. Fluorescence filters
are heat-sensitive and their function may be impaired if the heat protection filter is removed.
The reflected and transmitted illumination lamps are assigned to LED risk category 2 under
DIN EN 62471:2009. Do not look directly into the illumination light.
The desktop power supply units which are available as a microscopy accessory permit mains
voltages in the 100 to 240 V ±10%, 50/60 Hz range without the voltage setting on the
instrument having to be changed.
Desktop power supply units available as microscopy accessories should not come into contact
with moisture. If the housing is damaged, the desktop power supply unit should be taken out
of use. The microscope must only be operated with the desktop power supply unit contained in
the scope of delivery.
The operating manuals of the Axio Observer 431004-7144-001, the light sources and the
software must be carefully observed.
If it is determined that protective measures are no longer effective, the instrument must be
switched off and secured against inadvertent operation. Please contact ZEISS Service or the
ZEISS Microscopy Service to repair the instrument.
Please note that the Axio Observer is a precision opto-electronic device. Incorrect handling can
easily impair the functioning of the device, or even damage it, and will render any warranty
claims invalid.
Switching the Axio Observer 5 materials, 7 materials off using the standby button only turns off
the internal computer. The mains supply is not switched off.
The Axio Observer 7 materials can only be disconnected from the mains supply using the on/off
switch on the external VP232-2 power unit. Disconnect Axio Observer 5 materials from the
power supply.
4
SAFETY INSTRUCTIONS
431004-8044-010
Axio Observer materials
09/2015