Plunge Cutting - Tack life TCS115A Bedienungsanleitung

NOTE: To align the saw blade with the cutting mark, use the guide marks on the
front of the sole plate (Fig. 9). Use the 0° cutting mark (1) and the laser line (2)
for right angle cuts. Use the 45° mark (3) for 45° bevel cuts. The 45° mark will
allow for the extra material needed for the angle cut. Always make a test cut on
a scrap workpiece before cutting the new material.
ASSEMBLY AND OPERATING
GENERAL CUTTING – cont'd
WARNING: Do not force the circular saw. Use only enough force to keep
the blade cutting at full speed. Excessive pressure on the blade will cause
it to slow down and overheat, resulting in poor cut quality and damage to the
motor.
9. Turn laser OFF.

PLUNGE CUTTING

WARNING: To avoid loss of control, damage to the blade or damage to the
workpiece, always use extreme caution when making plunge cuts. It is not
recommended to plunge cut any material other than wood.
1. To plunge cut inside the edges of a workpiece, clearly mark the cutting line on
the workpiece.
2. Set the depth (Fig. 2) and set the bevel angle at 0° (Fig. 3).
3. Set the saw on the workpiece so the front edge of the sole plate (1) is flat on
the workpiece (Fig. 10).
4. Open the blade guard by rotating the blade guard lever (2) forward.
5. Align the saw blade with the cutting line (3) using the 0° cutting mark on the
sole plate and the laser line.
NOTE: Make sure the saw blade is inside the area to be cut out.
3
2
Fig. 9
21
1