Tack life TCS115A Bedienungsanleitung Seite 27

GENERAL
WARNING: When servicing, use only identical replacement parts. The use
of any other part may create a hazard or cause product damage.
DO NOT use solvents when cleaning plastic parts. Plastics are susceptible to
damage from various types of commercial solvents and may be damaged by
their use. Use a clean cloth to remove dirt, dust, oil, grease etc.
WARNING: Do not allow brake fluids, gasoline, petroleum-based products,
penetrating oils, etc. to come into contact with plastic parts. They contain
chemicals that can damage, weaken or destroy plastic.
DO NOT abuse power tools. Abusive practices can damage the tool and the
workpiece.
WARNING: DO NOT attempt to modify tools or create accessories. Any
such alteration or modification is misuse and could result in a hazardous
condition leading to possible serious injury. It will also void the warranty.
It has been found that electric tools are subjected to accelerated wear and
possible premature failure when they are used on fiberglass boats and sports
cars, wallboard, spackling compounds or plaster. The chips and grindings from
these materials are highly abrasive to electric tool parts such as bearings,
brushes, commutators, etc. Consequently, it is not recommended that this tool
be used for extended work on any fiberglass material, wallboard, spackling
compounds or plaster.
During any use on these materials it is extremely important that the tool is
cleaned frequently by blowing it out with an air jet.
WARNING: Always wear safety goggles or safety glasses with side shields
during all cutting operations. It is critical that you also wear safety goggles
or safety glasses with side shields and a dust mask while blowing dust out
of the circular saw with an air jet.
Failure to take these safety precautions could result in permanent eye or lung
damage.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient amount of
high-grade lubricant for the life of the unit under normal conditions.
Therefore, no further lubrication is required.
24