Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2
1
3
Fig. 10
6.Start the saw and slowly lower the blade onto the workpiece while holding the
blade guard lever forward to allow the blade to cut into the workpiece.
7.Continue lowering the blade into the workpiece until the full cutting depth has
been achieved. Continue sawing and complete the cut as required.
CUTTING USING THE EDGE GUIDE
Whenever possible, install the edge guide on the left hand side of the sole plate
(Fig. 11). This will place the majority of the tool weight on the larger portion of
the workpiece, making it easier to control the tool. If necessary, the edge guide
may be installed from the opposite side, but the edge guide mounting rod MUST
engage both of the edge guide slots in the sole plate.
Fig. 11
ASSEMBLY AND OPERATING
CHANGING THE LASER BATTERIES
The batteries that operate the laser will have to be replaced after considerable
use of the laser.
1.Turn the laser switch OFF.
2.Remove the laser cover screw (1) using a #2
screwdriver (Fig. 12).
22
Werbung
Inhaltsverzeichnis
