Setting The Cutting Depth - Tack life PES01A Bedienungsanleitung

7
Changing the blade
Switch off the tool and unplug the power cord. Disconnect the sole and lower it to its lowest position.
Lock the blade with the spanner supplied. Undo the locking screw and the washer. Take off the blade.
Install the new blade by following these instructions in the reverse order.

Setting the cutting depth

Switch off the tool and unplug the power cord. Undo the depth adjustment screw. Adjust the sole to
the desired sawing depth and tighten the screw.
Setting the sawing angle
Switch off the tool and unplug the power cord. The sawing angle can be set between 0° and 45°C.
Undo the two screws holding the sole. Turn the sole to the required angle. Tighten the screws to
lock the sole.
Parallel fence
The parallel fence is used to saw parallel with the edge of the workpiece. Switch off the tool and
unplug the power cord. Place the fence in the grooves at the front edge of the sole. Set the desired
sawing width and tighten the screws to lock the parallel fence.
Laser line indication
Laser line indication is used to make it easier to saw along the desired line.
IMPORTANT: Do not look into the laser beam –risk of eye injury.
DESCRIPTION
USE
- 03 -
1. Handle
2. Laser switch
3. Support handle
4. Laser line indication
5. Aluminium sole
6. Blade
7. Blade guard