Tack life TCS115A Bedienungsanleitung Seite 23

MATERIALS YOU CAN CUT
The circular saw is a versatile saw that allows you to cut many different types of
materials. Some of the materials include:
• Wood products such as lumber, hardwood, plywood, composition board and
paneling
• Masonite and plastic
NOTE: There are several different types of blades available. Generally, blades
with carbide- tipped teeth cut better and stay sharp longer.
Tooth count and configuration are also important. High tooth counts cut slower
and are best suited for making smooth cuts on thinner materials such as
paneling. Use the correct blade for your application.
GENERAL CUTTING
NOTE: Always make a test cut on a scrap workpiece to verify that all settings
are correct.
1. Make any adjustments to the saw before plugging it into the power source.
Adjustments include cutting depth, bevel cutting angle and edge guide (if
installed).
2. Clearly mark the workpiece to locate the position of the cut.
3. Hold a smaller workpiece with a vise. Clamp a larger workpiece to a work
bench or table.
DANGER: Any workpiece that is not adequately clamped in place or
properly supported for cutting may come loose or jamb the blade, causing
serious injury. Never hold the workpiece in your hand.
4. Make sure there are no nails, screws, clamps or foreign materials in the path
of the saw blade.
5. Turn the laser ON.
6. Place the front edge of the sole plate on the workpiece.
7.While firmly gripping the saw, and with the blade NOT in contact with the
surface to be cut, start the saw by depressing the lock-off button and then the
trigger switch.
8. Once the saw has reached full speed, gradually bring the moving blade into
contact with the workpiece at the appropriate location.
20