Tack life TCS115A Bedienungsanleitung Seite 13

EXTENSION CORD SAFETY
WARNING: Keep the extension cord clear of the working area. Position the
cord so it will not get caught on the workpiece, tools or any other obstructions
while you are working with the power tool.
Make sure any extension cord used with this tool is in good condition. When
using an extension cord, be sure to use one of heavy enough gauge to carry the
current the tool will draw. An undersized cord will cause a drop in line voltage
resulting in loss of power and overheating.
The table at right shows the correct size to use according to cord length and
nameplate ampere rating. If in doubt, use the next heavier gauge. The smaller
the gauge number the heavier the cord.
Be sure your extension cord is properly wired and in good condition. Always
replace a damaged extension cord or have it repaired by a qualified electrician
before using it. Protect your extension cord from sharp objects, excessive heat
and damp or wet areas.
Use a separate electrical circuit for your power tools. This circuit must not be
less than 14 gauge wire and should be protected with either a 15 AMP time
delayed fuse or circuit breaker. Before connecting the power tool to the power
source, make sure the switch is in the OFF position and the power source is the
same as indicated on the nameplate. Running at lower voltage will damage the
motor.
WARNING: Repair or replace damaged or worn extension cords immedi-
ately.
Select the appropriate extension cord gauge and length using the chart below.
When operating a power tool outdoors, use an outdoor extension cord
marked "W-A" or "W". These cords are rated for outdoor use and reduce the
risk of electric shock.
WARNING: Keep the extension cord clear of the working area. Position
the cord so it will not get caught on the workpiece, tools or any other
obstructions while you are working with the power tool.
10