Tack life TCS115A Bedienungsanleitung Seite 20

(4)with the 0° cutting mark (5) in the sole plate.
4. Tighten the edge guide locking screw to lock the edge guide into position.
NOTE: Do not over tighten as you may strip the threads.
5. Make a test cut on a scrap workpiece to verify the edge guide setting. Adjust
as necessary.
ASSEMBLY AND OPERATING
INSTALLING THE EDGE GUIDE – cont'd
1
5
3
2
4
Fig. 5
INSTALLING THE VACUUM ADAPTER
A workshop vacuum can be attached to the circular saw to collect much of the
dust created from cutting.
1. Place the small end of the vacuum adaptor
(1)over the vacuum port (2) on the blade housing (Fig. 6).
NOTE: Rotate the adaptor slightly while pushing it onto the vacuum port.
2. Attach a standard workshop vacuum to the large end of the adaptor.
NOTE: Not all of the cutting dust will be captured by the vacuum as some will be
thrown beyond the vacuum range.
17