Chauvin Arnoux DTR 8510 Bedienungsanleitung Seite 54

NOTE:
„ Selecting one transformer from the list will replace the values in the Present Nameplate immediately. The values can then be
changed in the Edit mode if needed.
„ Selecting Edit will allow the user to modify the values in the Present Nameplate.
„ The Edit process changes the values in the Present Nameplate only. The values previously stored would remain the same.
The stored List values can only be changed in DataView
„ In order to write the Present Nameplate value, you must press ENTER until Setup Nameplate is displayed. Otherwise, the
ratio will not be entered. If the up/down arrows are pressed after setting the ratio, then it performs a cancel operation and the
changes will not be saved.
REMEMBER: In order to move one level up and return to Configure Instrument, press the  and  keys simultaneously.
Text text text text.
4.3.3. SELECT TEST TYPE
1. From the top level of Configure Instrument, press the  or  key until Select Test Type appears on the display, then press
ENTER.
2. Select VT/PT or CT using  or  and press ENTER. The display will return to Select Test Type.
NOTE: Once the Test Type is selected, it is retained until changed by the user. If the instrument is turned OFF and turned
ON, the Test Type will be the same as last selected.
4.3.4. SELECT TEST MODE
1. From the top level of Configure Instrument, press the  or  key until Select Test Mode appears on the display, then press
ENTER.
2. Select Ratio or CONT/Ratio test using  or  and press ENTER. The display will return to Select Test Mode.
CONT/Ratio: Performs a Continuity test followed by Ratio test only in VT/PT. Continuity test is not available (N/A) in CT mode.
Ratio test: Performs only the Ratio test in the VT/PT or CT mode.
NOTE: Test Mode can also be selected from the Main Screen by pressing ENTER, which toggles the selection of CONT
and Ratio.
.
®
Figure 4-14
Figure 4-15
54