Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
„ Each Measurement Record will record the Present Nameplate along with other associated parameters and will be available
when the data is downloaded.
„ The Ratio of the nameplate values must be between 1 and 32767.
„ The Nameplate needs to be enabled. If the Nameplate is not enabled, the Deviation % will not be reported after the measure-
ments. Subsequently, the stored values will not have Nameplate and Deviation % in the Measurement Record.
NOTE: The Main Screen will display the Present Nameplate only if it is Enabled. If it is not Enabled, it will display "---" for
Primary and Secondary.
To configure the settings for the Nameplate, perform the following:
1.
Within the top level of Configure Instrument, press the or key until Setup Nameplate appears on the display, then press
ENTER.
2.
The display will show Enable with Yes and No choices. Press the key to select Yes (Enable Nameplate).
3.
The display will now show the following screen:
4.
Select List by pressing the key. The list can then be scrolled from 0 to 9 Nameplate values by using the or key. Select
the desired Nameplate by pressing ENTER. The display will return to Setup Nameplate.
5.
Press ENTER, then Yes () on Enable.
6.
Select Edit by pressing the key. The values in the Present Nameplate can be edited digit by digit by selecting each digit
with the or and then pressing the ENTER key. When the last digit on the Secondary is selected, the display returns to
Setup Nameplate.
Figure 4-9
Figure 4-10
Figure 4-11
Figure 4-12
Figure 4-13
53
Werbung
Kapitel
Inhaltsverzeichnis
