Parkside EURO 270/8/24 Bedienungsanleitung Seite 19

Anleitung_Euro_270_8_24_mehrspr:_
2. Make allowance for environmental
conditions
- Never leave the compressor in the rain.
Never use the compressor in damp or wet
conditions. Provide good lighting. Never
use the compressor near combustible
liquids or gases.
3. Protect yourself from electric shocks
- Avoid physical contact with earthed parts,
e.g. pipes, radiators, cookers, refrigerators.
4. Keep children away!
- Do not allow other persons to touch the
compressor or its cable. Keep them out of
your work area.
5. Keep your compressor in a safe place
- When the compressor is not being used it
should be kept in a dry, locked room out of
the reach of the children.
6. Do not overload your compressor
- It is better and safer to work within the
quoted power range.
7. Wear suitable work clothes
- Do not wear loose garments or jewellery.
There is a risk of them catching on moving
parts. Rubber gloves and non-slip shoes
are recommended when working outdoors.
Put on a hair net if you have long hair.
8. Never use the cable for any purpose
other than that intended
Never tow the compressor by its cable and
never pull the power plug out of the socket
by the cable. Protect the cable from heat,
oil and sharp edges.
9. Look after your compressor
- Keep your compressor clean so that it
works well and reliably. Follow the
maintenance instructions. Check the power
plug and cable regularly and have them
replaced by a specialist if you discover any
damage. Check any extension cables
regularly and replace if
damaged.
10. Pull out the power plug
- When the equipment is not in use, or
before starting any maintenance work.
11. Avoid accidental starts
- Make sure that the switch is turned to
OFF before you connect the compressor to
the power supply.
08.06.2007 9:58 Uhr Seite 19
12. Extension cables for outdoor use
- Use extension cables outdoors only if they
are approved and marked accordingly.
13. Concentrate at all times
- Watch your work. Be sensible. Do not use
the compressor if your mind is not on
your work.
14. Check the compressor for damage
- Before using the compressor again, check
the safety devices or any slightly damaged
parts to ensure that they are in good
working order. Check that the moving parts
are working correctly, that they do not jam,
and that no parts are damaged. Make sure
that all parts are fitted correctly, to ensure
that the equipment remains safe to use.
Unless otherwise stated in the operating
instructions, damaged guards and parts
have to be repaired or replaced by a
customer service workshop. Damaged
switches have to be replaced by a
customer service workshop.
15. Important!
- For your own safety, use only such
accessories and auxiliary equipment as are
listed in this manual or which are
recommended and specified by the
manufacturer. There is a high risk of
suffering a serious accident if you use tools
or accessories which are not listed in this
manual or in the catalogue of
recommended tools and accessories.
16. Have an electrician carry out repairs
- Repairs are to be carried out only by a
qualified electrician. If not, the user may
suffer serious accidents.
17. Noise
Use ear muffs when you use the
compressor.
18. Replacing the power cable
To prevent injury, damaged power cables
may only be replaced by the manufacturer
or a qualified electrician.
GB
19