Cleaning And Maintenance - Parkside EURO 270/8/24 Bedienungsanleitung

Anleitung_Euro_270_8_24_mehrspr:_
Valve adapter (Figure 16)
Uses: Fits bicycle tyre valves.
The valve adapter makes inflating bicycle
tyres easy.
Adapter 3 (Figure 17)
Uses: For all valves with an internal
diameter of over 8 mm.
You can use this adapter for the Splash-
Pool or Boat, for example.
TIP: When inserting the adapter, ensure
that the opening of the adapter is towards
the open side of the non-return valve (see
diagram). This will ensure that any
problems which may arise can be avoided.
Important! The valve cap must be opened
slightly by squezing it.
Adapter 4 (Figure 18)
Uses: For screw valves.
This adapter can be used for all ordinary
inflatable dinghies, such as the Boat,
kayaks or other large inflatables such as
pools, which are fitted with a screw valve.
Vent adapter (Figure 19)
Uses: For deflation valves
Deflation valves are often found with other
valves (standard valves, screw valves...)
on many large volume inflatables, such as
the Flock Bed.
TIP: The inflatable can initially be inflated
using the deflation valve. However, you
should finish inflating the item using the
inflation valve provided. Adapter 3 or 4 can
be used for the inflation valve.
08.06.2007 9:58 Uhr Seite 23

10. Cleaning and maintenance

Important!
Pull the power plug before doing any
cleaning and maintenance work on the
appliance.
Important!
Wait until the compressor has completely
cooled down. Risk of burns!
Important!
Always depressurize the tank before
carrying out any cleaning and maintenance
work. To do so, connect the supplied blow-
out pistol to the compressed air hose with
the quick-lock coupling (6). Then actuate
the blow-out pistol until no more air is
blown out and the pressure gauge (9)
indicates a complete decrease in pressure.
10.1 Cleaning
Keep the safety devices free of dirt and
dust as far as possible. Wipe the
equipment with a clean cloth or blow it with
compressed air at low pressure.
We recommend that you clean the
appliance immediately after you use it.
Clean the appliance regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may be
aggressive to the plastic parts in the
appliance. Ensure that no water can get
into the interior of the appliance.
You must disconnect the hose and any
spraying tools from the compressor before
cleaning. Do not clean the compressor
with water, solvents or the like.
10.2 Condensation water
The condensation water must be drained off
each day by opening the drain valve (18) (on
the floor of the pressure vessel).
Important! The condensation water from
the pressure vessel will contain residual oil.
Dispose of the condensation water in an
environmentally compatible manner at the
appropriate collection point.
GB
23