Setting Up; Safety Information; Check Contents Of Pack; Connecting The Receiver - AUDIOLINE TEL4 CLIP Bedienungsanleitung

3

Setting up

3.1

Safety Information

NOTE! Before setting up, it is essential that you read the Safety Information at
the beginning of this operating manual.
3.2

Check contents of pack

The following items are supplied:
one telephone
one instruction manual
one spiral cable
one wall adapter
3.3

Connecting the receiver

After unpacking your new telephone, you must first connect the telephone
receiver to the base unit. The spiral cable needed for this has two identical
connections so that there can be no confusion. First take one end of the spiral
cable and plug it into the socket at the bottom of the receiver. Now plug the
other end into the socket on the left-hand side of the base unit.
3.4

Insert batteries

Before connecting your new telephone to the telephone network, the supplied
batteries should be installed. Please always use four type AA 1.5V alkaline
batteries. The batteries are required for the display and other features of the
telephone. Before installing or changing the batteries make sure that the
telephone is not connected to the telephone network. The battery
compartment is to be found on the underside of your telephone.
1. Open the battery compartment with a small screwdriver or a pointed object.
2. Insert the batteries. Ensure that the polarity is correct. Push the "-" pole
onto the small spring and then press the "+" pole downwards.
3. Close the battery compartment.
The battery must be changed when the display shows
3.5

Connecting the telephone cable

Connect the telephone cable provided to the telephone jack and the socket on
the rear of your telephone. Check that the plug is properly engaged by pulling
gently on the cable. If you do not have the right connection socket, please
refer to your local network office.
- Setting up -
one telephone connecting cable
one receiver
four AA batteries
.
25