3
Setting up
3.1
Safety Information
NOTE Before setting-up, it is essential that you read the General Information at the
beginning of this manual.
3.2
Check contents of pack
The following items are supplied:
one base station with main power supply
three handsets with belt clips
one telephone connecting cable
3.3
Connecting the base station
Position the base station near to your telephone connection socket and to a mains
socket. Your telephone works using Touch-Tone Dialling.
1.
Insert the plug of the power supply into the socket on the rear of the base
station and plug the power supply into a properly installed 230 V mains socket.
The plug-in power supply for the base station must always be connected. For
safety reasons, use only the plug-in mains power supply provided.
2.
Connect the telephone cable supplied to the telephone socket and the
telephone jack on the rear of the base station. Use only the new telephone
cable provided.
3.
If required, clamp the two cables in the cable channel underneath the foot
support and then run these through the two openings towards the rear.
Note: The two plugs must audibly click into place so that they do not fall out again.
3.4
Connecting the charger
Set up the charger in the desired place within reach of a electricity supply socket.
- Setting up -
oner charger with mains power supply
fourstandard batteries
one instruction manual
67