Wall Mounting - AUDIOLINE TEL4 CLIP Bedienungsanleitung

- Setting up -
3.6

Wall mounting

Your telephone is also suitable for wall mounting. For wall-mounting, the
adapter provided must be fixed to the rear of the telephone. To do this, turn
the telephone over and fit the adapter into the openings marked in the housing
(see left-hand diagram). Then slide the adapter upwards until it audibly
engages (see right-hand diagram).
Use two screws for fixing to the wall. Drill two holes 83 mm apart, vertically
one above the other, and leave the screws protruding 5 mm from the wall.
Now place the telephone over the screws and push down slightly.
When using the telephone on a table, the receiver hanging hook must be in
the lowered position, as shown in Diagram A (factory setting). When mounting
on the wall, the receiver hanging hook is pulled out and turned. For more
detail, see Diagram B.
Abb. A Abb. B
26