Setting Up; Safety Information; Check Contents Of Pack; Connecting The Base Station - AUDIOLINE STUDIO 80-B Bedienungsanleitung

3

Setting up

3.1

Safety information

NOTE: Before setting up, it is essential that you read the Safety Information at the beginning of
this operating manual.
3.2

Check contents of pack

The following items are supplied:
one base station with power supply
two handsets with belt clip
one telephone connecting cable
3.3

Connecting the base station

Position the telephone near to your telephone connection socket and to a mains socket.
1. Insert the plug of the power supply into the socket on the underside of the base station and
plug the power supply into a properly installed 230 V mains socket. The plug-in power
supply for the base station must always be connected. For safety reasons, use only the
plug-in mains power supply provided.
2. Connect the telephone cable supplied to the telephone socket and the telephone jack on
the underside of the base station. Use only the new telephone cable provided.
3. Run the two cables through the two cable channels to the rear of the base station.
3.4

Connecting the charger

Set up the charger within reach of a electricity supply socket. Insert the red connector on the
lead from the transformer plug in the socket on the underside of the charger and insert the
transformer plug in a 230V supply socket installed in accordance with regulations. For safety
reasons, use only the transformer plug supplied. Press the cable into the cable channel leading
to the rear of the charger.
3.5

Fitting standard batteries

To fit the standard rechargeable batteries supplied into the handset, press
on the upper edge of the battery compartment and slide it downwards.
Now insert the batteries taking care to ensure that the polarity is correct.
Close the battery compartment cover.
Important note: Place the handset in the base station with the display to the front for at least
16 hours. The telephone may malfunction if the batteries are not properly charged. The charging
light on the base station will come on.
3.6

Charging the standard batteries

The rechargeable batteries for your telephone have a stand-by time of max. 100 hours at room
temperature and a maximum talk time of up to 10 hours. The current battery capacity is shown
in the display.
Full
If the battery capacity is too low, the symbol will flash in the display and you will hear warning
tones every 60 seconds.
To charge the batteries, place the handset in the base station with the display to the front.
44
- Setting up -
one charger with power supply
(big)
four standard batteries
one instruction manual
Half
(small)
+
Low