Setting Up; Safety Information; Check Contents Of Pack; Connecting The Base Station - AUDIOLINE 5300TECH Bundle Bedienungsanleitung

3

Setting up

3.1

Safety information

NOTE: Before setting up, it is essential that you read the Safety Information at
the beginning of this operating manual.
3.2

Check contents of pack

The following items are supplied:
one base station with power supply
(big)
two handsets with belt clip
one telephone connecting cable
3.3

Connecting the base station

Position the telephone near to your telephone connection socket and to a mains
socket.
1. Insert the plug of the power supply into the socket on the underside of the
base station and plug the power supply into a properly installed 230 V
mains socket. The plug-in power supply for the base station must always be
connected. For safety reasons, use only the plug-in mains power supply
provided.
2. Connect the telephone cable supplied to the telephone socket and the
telephone jack on the underside of the base station. Use only the new
telephone cable provided.
3. Run the two cables through the two cable channels to the rear of the base
station.
3.4

Connecting the charger

Set up the charger within reach of a electricity supply socket. Insert the red
connector on the lead from the transformer plug in the socket on the underside
of the charger and insert the transformer plug in a 230V supply socket installed
in accordance with regulations. For safety reasons, use only the transformer
plug supplied. Press the cable into the cable channel leading to the rear of the
charger.
48
- Setting up -
one charger with power supply
four standard batteries
one instruction manual
(small)