Connecting The Telephone; Fitting The Desk Support; Private Exchanges - Setting Up For T-Net - AUDIOLINE TEL28 Bedienungsanleitung

3.5

Connecting the telephone

Connect the telephone cable supplied to the telephone socket and the telephone
jack on the underside of the telephone. Then feed the cable out of the
telephone housing either upwards or downwards through the cable guide. Clip the
cable firmly in the cable channel. The AUDIOLINE 28 telephone works using the
tone dialling system.
3.6

Fitting the desk support

If you intend to use your telephone on a desk, then the desk support supplied
must be fitted. To do this, turn the telephone over. Now insert the two upper
hooks into the openings provided and push the desk support firmly home.
If you ever need to remove the support, press gently on the middle clips on the
upper edge and then pull the desk support off.
In the receiver rest there is a small hanging device, which is used when the
telephone is wall mounted. This hanging device is not required when the
telephone is used on a desk, as it impedes the lifting of the receiver. Using a small
screwdriver, turn this hanging device until the screw is completely flush and its
upper end does not protrude at all.
3.7

Private exchanges - Setting up for T-NET

You can use the "R" signal button on your telephone on private exchanges and
when using DEUTSCHE TELEKOM's T-Net functions. If you use neither a private
exchange or the T-NET-functions of the DEUTSCHE TELEKOM, no adjustments
must be made here.
Private exchanges
If you have connected your telephone to a private exchange, you can use all the
facilities such as call transfer, automatic recall, etc. The "R" signal button gives
you access to these facilities. The FLASH time "100ms" (factoty setting) will be
required on a private exchange. To make this setting, move the slide switch on
the underside to the "100ms" position. You can find out from the dealer from
whom the equipment was purchased whether your telephone will work on your
private exchange without any problems and which other facilities you will have
access to.
T-NET functions
Your telephone supports the most important DEUTSCHE TELEKOM added value
services (e.g. brokering, call waiting, three-way conferencing, etc.). Please
contact DEUTSCHE TELEKOM to gain access to these functions (some of which are
subject to charge). When using T-NET functions, move the slide switch on the
underside to the "300ms" position.
22
Downloaded from www.Manualslib.com
- Commissioning -
manuals search engine