Setting Up; Safety Notices; Checking The Contents Of The Package; Connecting The Base Station - AUDIOLINE DECT 5500 plus Bedienungsanleitung

2.

Setting up

2.1

Safety notices

NOTICE! Before switching on, do not fail to read the safety notices on of the beginning
of these instructions.
2.2

Checking the contents of the package

The package should contain:
one base station
one handset with batteries
one telephone connection cable
2.3

Connecting the base station

Set up the AUDIOLINE DECT5500+ within reach of a telephone socket and an electricity
supply socket.
1. Insert the connector on the lead from the transformer plug in the socket on the
underside of the base station and insert the transformer plug in a 230V supply socket
installed in accordance with regulations. The base station transformer plug must
always be connected. For safety reasons, use only the transformer plug supplied.
2. Connect the telephone cable supplied between the telephone socket and the
corresponding socket on the underside of the base station. Only use the new
telephone cable supplied.
3. Press the two cables into the two cable channels leading to the rear of the base
station.
2.4

Exchange the batteries

The rechargeable batteries (AAA, 1.2V, 550mAh) have a stand-by time of max. 350
hours and a maximum talk time of up to 14 hours.To fit or change the batteries, open
the battery compartment cover and insert the new batteries. Take care to ensure that
the polarity is correct and close the battery compartment cover. Always use rechargeable
batteries, type AAA 2 x 1.2V, only.
To increase performance, you can also use rechargeable batteries of the same type with
up to 1300 mAh capacity. In this way, the stand-by time is increased to ca. 700 hours
and the talk time to ca. 28 hours.
Important notice: Place the handset on the base station, with the display facing
forwards, for at least 16 hours. If the batteries are not properly charged, the telephone
may fail to function correctly. While the handset is charging, the battery capacity symbol
in the display will blink. The
position.
42
- Setting Up -
one supply cable
one belt clip
one set of directions for use
indicator lights as soon as the handset is placed in