PeakTech 1070 Bedienungsanleitung Seite 35

4.4. Resistance measurement ()
1. Connect red test lead to V//mA jack, black test lead
COM jack.
2. Set the FUNCTION switch to the -position.
3. Connect the test leads across the resistor under
measurement.
4. When measuring the resistance, the power should be
turned off and in short circuit statues by connecting the
two test leads.
Note:
When you short the test leads in the 200  range, your
meter display a small value (no more than 0.3 ). This
value is due to your meters and test leads internal
resistance. Make a note of this value and subtract it from
small resistance measurements for better accuracy.
-34-