CEA Matrix 250 HF Bedienungsanleitung Seite 22

• Adjust the parameter by turning the special dial
6A)Press the SET key until the RED led of the 1
level BASIC CURRENT I
flashing
• Adjust the parameter by turning the special dial
7A)Press the SET key until the RED led of the
PULSATION FREQUENCY (0.5 ÷ 500 Hz)
starts flashing
• Adjust the parameter by turning the special dial
ATTENTION: go on to point 9)
Slow ON-PULSE
3B)Press the "pulsation" button until the desired
function is working (the ON PULSE LIGHT is
flashing)
4B)Press the SET key until the GREEN led I
the RED led Ip will start flashing; adjust the
1st level PEAK CURRENT I
5B)Press the SET key until the RED led of the
2nd level of PEAK CURRENT I
ing (5 ÷ 250 A)
st
(5 ÷ 250 A) starts
1b
and
1
(5 ÷ 250 A)
1p
starts flash-
2p
22
• Adjust the parameter by turning the special dial
6B)Press the SET key until the RED led of the 1 st
level BASIC CURRENT I
flashing
• Adjust the parameter by turning the special dial
7B)Press the SET key until the RED led of the
PEAK TIME t (0,01 ÷ 0,99 sec) starts flashing
p
• Adjust the parameter by turning the special dial
8B)Press the SET key until the RED led of the
BASIC TIME t (0,01 ÷ 0,99 sec) starts flash-
b
ing
(5 ÷ 250 A) starts
1b