Slave Mode; Sound-Control Mode; System Settings - Cameo OCTAFLY XS Bedienungsanleitung

CONFIGURING STANDALONE MODE
Press the MODE button repeatedly until "ModE" appears in the display. Now press ENTER twice and select the desired standalone mode by
using the UP and DOWN buttons as required (Soun, SLAV, AUto). Confirm your selection with ENTER.
-> ENTER ->

SLAVE MODE

After you have selected Slave mode as described in CONFIGURING STANDALONE MODE, confirm the selection by pressing ENTER. Connect the
slave and the master units (same model) with a DMX cable and enable one of the standalone modes on the master unit: automatic-control, or
sound-control. Now the slave unit will follow the master unit.
AUTOMATIC CONTROL MODE (AUTO)
Select one of the 13 different auto programmes (Au00 - Au12) and configure the programme running speed (SP00 - SP99). After you have
activated the automatic-control mode as described in CONFIGURING STAND-ALONE MODE, press ENTER. The characters in the display will
begin to flash and you can select the desired programme by using the UP and DOWN buttons. Confirm selection with ENTER, select menu
item SPxx using the UP and DOWN buttons, and confirm selection with ENTER. You can now adjust the programme run speed as required
from 00 to 99 with the UP and DOWN buttons. (00= minimum, 99 = maximum speed). Confirm with ENTER. If no further commands are
entered, the display automatically returns to the main menu, and the programme number is displayed.
-> ENTER ->

SOUND-CONTROL MODE

Activate the sound-control mode as described in CONFIGURE STANDALONE MODE in order to control the spotlights via the built-in
microphone (bass impulses). Now set the microphone sensitivity as required using the UP and DOWN buttons (SE00 = minimum - SE99 =
maximum sensitivity). If no further commands are entered, the display automatically returns to the main menu after about 10 seconds, and
"Soun" is displayed.
-> ENTER ->

SYSTEM SETTINGS

To adjust system settings, press the MODE button repeatedly until the display shows "Set". Confirm with ENTER. You can now use the UP
and DOWN buttons to select and edit one of the following menu items.
-> ENTER ->
<- MODE
6
UP/DOWN /
-> ENTER ->
UP/DOWN
-> ENTER ->
UP/DOWN -
-> ENTER ->
UP/DOWN
<- MODE
on = display permanently on
off = display goes out after
about 60 seconds of
inactivity
-> ENTER ->
<- MODE
With the help of this menu point, you define
which operating mode is enabled
if the DMX signal is interrupted
when in DMX-mode,
-> ENTER ->
<- MODE
Restore to
factory setting
-> ENTER
/
<- MODE
UP/DOWN -
UP/DOWN -
-> ENTER
<- MODE
/
UP/DOWN
/
UP/DOWN
the last DMX Blackout
command
is retained.
/
UP/DOWN
Restore to Do not reset
factory setting
-> ENTER
<- MODE
-> ENTER
<- MODE
-> ENTER
-> ENTER
-> ENTER