Installing The Magnet Rings; For Hollowtech Ii - Pioneer SGY-PM900H79 Benutzerhandbuch

Installing the Magnet Rings

EN
Attach the magnet rings to the left and right sides of the bottom bracket (BB).
The installation method is different depending on the bottom bracket.

For Hollowtech II

Uses magnet ring attachment provided with the product.
1
Clean the area around the bottom bracket and confirm that the bottom bracket is tight.
If the bottom bracket is not tight, it could result in injury or damage to parts.
If the bottom bracket is dirty, clean it thoroughly with a clean rag.
2
Remove the clear non-adhesive backing paper from the inside of the magnet rings.
3
Align the clips on the magnet rings (3 locations) with the indents on the attachment, and press them in
strongly until you hear a click.
•
Be careful that you do not bend the hooks on the magnet rings.
4
Place the bicycle in a level place and mount it on a trainer.
Adjust the front wheel so that the front and back wheels are the same height.
5
Attach a level to the magnet ring.
Use the double-sided tape for the level to stick the long side of the level so it covers the "R" on the right side and the "L" on
the left side.
26