Tying Down the Right Transmitter
Use the cable ties (provided) to fasten the transmitter to the crank set. There are two places to thread the cable ties.
•
The cable ties provided are for mounting the right transmitter. Use the new cable ties provided if you replace the chain ring.
•
The places to thread the cable ties are different for a standard crank set and a compact crank set.
This procedure uses a standard crank set for the explanation.
Compact crank set
1
Arrange the right-side transmitter and the crank set, and then insert the cable ties.
•
Insert the cable ties so their locking mechanism is facing as shown in the diagram.
2
Wrap the cable tie around the spider arm and pass it through the holes in the right transmitter and
tighten it.
Standard crank set
EN
23