Setting The Sensors - Pioneer SGY-PM900H79 Benutzerhandbuch

Setting the Sensors

EN
1
Cut off two 5-mm pieces of double-sided tape for the sensor guide, stick it to the left and right sensor
guides in the position shown in the diagram and remove the non-adhesive backing paper with tweezers.
2
Insert the sensors into the left and right sensor guides.
Press on the strain gauge unit, press from above the position you stuck on the double-sided tape.
Left side
Press on the neck part of the strain gauge unit. For the right sensor, insert the junction box into the sensor guide. For the left
sensor, insert the transmitter into the sensor guide.
Left side
•
Be careful that you do not force or pull too hard on the junction cable on the right sensor.
• If the strain gauge unit comes off, lightly shape the neck of the strain gauge unit so it fits the sensor guide, and start over from step 1.
3
Remove all the non-adhesive backing paper from the sensors.
While pressing on the neck of the strain gauge unit, use tweezers to remove the clear non-adhesive backing paper from the
strain gauge unit.
Use tweezers to remove the white non-adhesive backing paper from the right-side junction box and the left-side transmitter.
Be careful that the strain gauge unit does not come off of the sensor guide. If it does come off, put the non-adhesive backing
paper back on, and repeat the procedure from step 1.
14
Right side
Right side