Checking Operation Of The Sensors - Pioneer SGY-PM900H79 Benutzerhandbuch

Checking Operation of the Sensors

EN
Before installing the sensors, confirm that they operate correctly.
1
Use a Philip's screwdriver to loosen the screws and remove the left and right transmitter covers.
Left side(screws: 4 x)
2
Remove the batteries if there are in the left and right transmitter.
3
Check that the mode switches are in pedaling mode.
Left side
4
Insert the batteries (CR2032), confirm that the green LEDs light within a few seconds and flash for 10
seconds.
Left side
•
Using any battery other than CR2032 batteries could damage the product.
•
If the LEDs do not light, or if only one side lights, replace the batteries. If they still do not light, the batteries may be dead. Replace them
with new batteries.
•
If the LEDs light red, refer to Troubleshooting (page 47).
5
Remove the batteries, install the transmitter's cover and tighten the screws.
Use a tool that can measure the torque to tighten the screws.
• Tightening torque: 18 cN•m
•
Tighten the screws on the left transmitter in a diagonal pattern.
8
Right side(screws: 3 x)
Right side
Right side