Operation; Music Control; Internal Programs - Cameo MULTI PAR Bedienungsanleitung

OPERAtiOn:

nOtE:
After being switched on, during the boot process, the
LED lighting system will show various information in the
display: "Software Update, Please Wait..." (for service
purposes only), the software version "Software V1.xx" and
"WELCOME TO cameo". After this process, the Multipar
lighting system is ready for use.

MuSiC COntROl

Press the MODE button repeatedly until "SOUND MODE"
appears on the display. Now the lighting system is
controlled by the built-in microphone and follows the
beat of the music. Press the ENTER button. The cursor
appears in the "SENS:xx" field in the bottom line of the
display. Now you can use the UP and DOWN buttons to
adjust the microphone sensitivity (00 - 31), whereby "00"
means minimum sensitivity and "31" means maximum
sensitivity, then confirm with ENTER. Simultaneously, the
cursor jumps to the "FQN: xx" field. Use the UP and DOWN
buttons to set the number of repetitions for the individual
programs. "FQN:01" stands for a single repetition, "FQN:99"
for 99 repetitions of the programs. Press ENTER to confirm
the input.

intERnAl PROgRAMS

Press the MODE button repeatedly until one of the 14
internal programs appears on the display:
01.StAtiC (static colours)
To change the colour in STATIC program 01, press ENTER
repeatedly until the cursor appears in the "CL:xxxx" field
in the bottom line. Now, one of the basic colours or a co-
lour combination can be selected using the UP and DOWN
"BLAC" (Blackout) buttons.
R = red
G = green
B = blue
RG (red and green) = yellow
GB (green and blue) = cyan
RB (red and blue) = magenta
RGB (red, green and blue) = white
Confirm the input with ENTER. The cursor jumps to the
"Flashxx" field. You can now add a stroboscope effect to
the previously selected colour.
10