Dmx Mode; Slave Mode - Cameo MULTI PAR Bedienungsanleitung

OPERAtiOn:

DMX MODE

This menu item makes it possible to select both the DMX
start address and the DMX mode in which the multi-PAR
lighting system should operate. Press the MODE button
repeatedly until "DMX MODE" appears on the display.
Then press ENTER. The cursor appears in the "ADDR:xxx"
field. Use the UP and DOWN buttons to select the DMX
start address of the lighting system from 001 to 512.
Confirm the input with ENTER. Simultaneously, the cursor
jumps ahead to the "CH:xx" field. There are 8 different
DMX modes that can be selected using the UP and DOWN
buttons. Confirm the input with ENTER. The DMX modes
are explained on the following pages of this manual.

SlAVE MODE

If you want to control the LED multi-PAR lighting system
either using the optional footswitch or by a second
CLMPARCOB1 (master) in one of the standalone modes, the
"SLAVE MODE" must be selected. Press the MODE button
repeatedly until "SLAVE MODE" appears on the display.
The connection between the footswitch and the multi-PAR
lighting system is achieved via a 5-pin DMX cable and the
connection between master and slave unit via a 3-pin DMX
cable, whereby the DMX output of the master unit must be
connected to the DMX input of the slave unit.
nOtE: The illumination of the LC display switches off
automatically after approx. 50 seconds of inactivity.
Pressing any one of the 4 control buttons will turn the
illumination of the LC display on again.
16