Setting The Cutting Depth - Cocraft DMY012-180 Bedienungsanleitung

21. Parallel guide
Set-up
Warning: Always remove the battery from the saw before changing the blade,
performing any adjustment, service or maintenance.
Setting the blade angle
1. Undo the locking knob (12).
2. Set the desired bevel angle, 0–45°.
3. Tighten the locking knob.

Setting the cutting depth

1. Lift the locking lever (3).
2. Lower the base plate (2) to the desired
cutting depth.
3. Press the locking lever back down to lock
the base plate at the new depth setting.
21
12
3
9