Checking The Machine Setting - Lagler SUPERHUMMEL Betriebsanleitung

ENGLISH
MAINTENANCE WORK AND REPLACEMENT OF WEARING PARTS
Fig. 43 Tilt the machine backwards (1). Ensure that the
machine is standing securely (2)!
Fig. 44 Remove the current setting fixture from the right-
hand wheel (seen from below).
Fig. 45 If the machine is sanding more heavily on side A,
the wheel must be adjusted in the direction of B.
If the machine is sanding more heavily on side C,
the wheel must be adjusted in the direction of D.
88
7

7.4 CHECKING THE MACHINE SETTING

ATTENTION!
The best working result is achieved when the sanding
drum sands centrally! Only with this setting is it possible to
avoid the belt from sanding too deep on one side, resulting
in unwanted sanding tracks!
From time to time, or as a result of incorrect transportation,
it is possible for the machine to become incorrectly adjusted.
Incorrect adjustment is indicated by one-sided sanding of the
sanding drum, which can lead to sanding tracks and complaints.
Correction of machine settings is performed as follows:
1 Lift the sanding drum off the floor by turning the lowering
lever at the handle upwards (Fig. 12).
2 Switch off the machine and pull the power plug out of
the socket!
3 Tilt the machine backwards over the safety guards so that
you can see the wheel bearings (Fig. 43, 1). Ensure that
the machine is standing securely (Fig. 43, 2)!
4 The wheel on the belt guard side can be adjusted by
releasing the tension nut. The other wheel is firmly fixed.
5 For setting, first take the actual position of the adjustable
wheel using the setting fixture (see tool bag). Position the
fixture against the machine housing in such a way that it
rests not only against the machine housing on both sides,
but also at the adjustable wheel (Fig. 44). If necessary, turn
the threaded pin of the setting fixture. To do this, release
the nut of the setting fixture.
6 If the machine is sanding more heavily on the belt guard
side (A in Fig. 45), the wheel must be adjusted away from
the belt guard (direction of B in Fig. 45).
If the machine is sanding more heavily on the side cover
side (C in Fig. 45), the wheel must be adjusted towards
the belt guard (direction of D in Fig. 45).
Now adjust the threaded pin of the setting fixture in the
relevant direction by the required amount.
SUPERHUMMEL
01.05.2014