Lagler SUPERHUMMEL Betriebsanleitung Seite 78

ENGLISH
Fig. 23 Loosen the two motor nuts ...
Similar to figure.
Fig. 24 ... until the two nuts used to fit into the motor
bearing bracket are exposed.
Similar to figure.
Fig. 25 Release the V-belt tension by loosening the
tensioning bolt at the motor.
Similar to figure.
Fig. 26 Remove the fan V-belt.
Similar to figure.
78
6
TRANSPORT AND STORAGE
4 Remove the belt guard.
5 Loosen the two motor nuts at the motor bearing bracket
(Fig. 23).
The motor nut must only be backed out from the fitting
between the motor nut and motor bearing bracket, and
not completely removed (Fig. 24).
6 Release the tension of the V-belts by turning the tensioning
bolt at the motor counterclockwise (Fig. 25).
CAUTION!
RISK OF INJURY:
During dismantling and mounting the V-belts, take care of
your fingers
7 Turn the motor pulley and allow the fan V-belt to run off
the motor pulley (Fig. 26).
8 Turn the lower pulley and allow the drive belt to run off
the lower pulley (Fig. 27).
If necessary, use the box wrench (see tool kit) to turn the
lower pulley exclusively clockwise!
ATTENTION!
Only turn the nut with the box wrench at the lower pulley
clockwise, as otherwise the nut will work loose (left-hand
thread)!
Fig. 27 Allow the drive belt to run off the lower pulley.
If necessary use the box wrench (see tool bag)
to help you, but turn the box wrench exclusively
in the clockwise direction in order not to loosen
the nut of the lower pulley.
Similar to figure.
danger of crushing!
SUPERHUMMEL
01.05.2014