Operation - Abicor Binzel MB EVO PRO 501 Betriebsanleitung

5 Handle operating elements
5 Handle operating elements
NOTICE
• Please make sure that the shutdown procedures for all components mounted in the
welding system are strictly observed before putting out of operation begins.
The trigger's two-cycle mode can be activated when using a standard welding torch. Further
operating modes and handle modules depend on the welding power source and must be
ordered separately.
5.1 Two-cycle trigger function
Fig. 10 Two-cycle trigger function
1 Press and hold the trigger on the handle = start welding.
2 Release the trigger = stop welding.

6 Operation

1 Open the shielding gas cylinder and switch on the power source.
2 Set the welding parameters.
3 Start welding.
7 Putting out of operation
NOTICE
• As liquid-cooled cable assemblies start to leak when they overheat, the cooling unit
should continue running for approx. 5 min. after welding.
1 Stop welding.
2 Wait until the shielding gas post-flow time has passed and then switch off the power source.
3 Close the valve on the shielding gas cylinder.
EN - 12
Start welding Stop welding
MB EVO PRO/MB EVO
BAL.0414.0 • 2018-08-01