Operating The Locomotive - Märklin T 9.3 Series Anleitung

2.4.1.2 Operating the locomotive

with Digital
To operate the locomotive with Märklin
Digital, the locomotive address is
entered on the Control-Unit (6021) or
with a Control-80 f (6036) locomotive
controller connected to it. The loco-
motive's speed is increased by turning
the speed control knob to the right
and is decreased by turning this knob
to the left. The direction of travel is
changed by turning the speed con-
trol knob to the left past the "0" set-
ting. The locomotive's headlights
can be turned on with the "function"
button and off with the "off" button.
When turned on, the headlights are
on in the direction of travel.
Four auxiliary functions can be switched
on with the buttons "f1" to "f4".
f1 = smoke generator on/off
f2 = bell sound effects on/off
f3 = whistle sound effects on/off
f4 = Telex at the rear
of the locomotive on/off
2.4.1.3 Operating the locomotive
with Delta
To operate the locomotive with
Märklin Delta you use the Delta-Mobil
to select the address that has been
set on the former. The locomotive will
run forward when you turn the speed
control knob to the right of the center
position. Turning the speed control
knob to the left of the center position
will cause the locomotive to run in
reverse. The headlights change direc-
tion with the direction of travel and
are on all of the time. The maximum
power output of the Delta-Station is
sufficient to operate 2 to a maximum
of 3 single motor locomotives at the
same time.
2
Operation
During operation with the Delta-
Station, the f1 function (smoke gene-
rator) of the functions f1 to f4 is
always turned on. The other func-
tions are always turned off. If you will
be operating the locomotive for long
periods of time without adding smoke
fluid to the smoke generator, we
strongly recommend removing the
latter from the smoke stack. The
steam locomotive sound effects
can be turned on manually in Delta-
operation (see section 2.5).
19