Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2
Operation
It is best to carry this locomotive
by grasping the front and rear buffer
beams.
Tip:
Handling the locomotive by the water
tanks may cause separately applied
piping on the right side under the
water tank to become bent. Please
be careful of the separately applied
parts on the locomotive's roof and
boiler (example: the delicate imitation
whistle on the roof), so that they do
not become bent or broken when
handling the locomotive.
14
2.1 Minimum Radius Required
For Operation
This locomotive can be run on curved
track with a minimum radius of at
5
least 600 mm (23-
⁄
"). As delivered
8
from the factory the front coupler is
not suitable for this radius. After the
front coupler has been converted, it
can also be used on this small a curve.
2.1.1 Converting the locomotive
5
for 600 mm (23-
⁄
") radius
8
curved track
1. First remove the two lines at the
front of the boiler on the right.
These lines are only plugged into
their mounting holes. Now remove
the complete boiler (also plugged
into its mounting position).
1 a
1 b
2. Remove coupler and brake hoses.
Werbung
Inhaltsverzeichnis
