Troubleshooting - switel DCT 527 Bedienungsanleitung

17

Troubleshooting

Should problems arise with the telephone, refer to the following information. In the case of claims under the terms of guarantee, contact your sales outlet.
There is a 2 year period of guarantee.
Faults Corrective measures
No connection to base -
station possible
No telephone calls -
possible -
-
-
-
Connection is disturbed or -
cut off -
The system no longer -
responds or is in an
undefined state
The charging control lamp -
does not light up
The handset switches -
itself off
Display is dark -
The caller number display -
(CLIP) does not function
-
CL" flashes in the -
answering machine
display
The answering machine -
does not take any calls -
No memo can be recorded -
No remote access func -
tions can be executed -
- Troubleshooting -
Check that the handset has been registered on the base station with the correct PIN.
The telephone line is not connected properly or is defective. Only use the telephone connection cable supplied.
Test whether the telephone connection is in order by using another telephone.
The power adaptor plug is not plugged in or there is a complete power failure.
The rechargeable batteries are empty or defective.
The handset is too far from the base station.
The handset is too far from the base station.
The base station is in an unsuitable location.
Disconnect the power adapter plug briefly from the power socket.
Place the handset correctly in the base station, clean the contact surfaces on the handset and the base station with a soft,
dry cloth.
Place the handset in the base station for 14 hours. If this does not help, replace the rechargeable batteries.
Caused by direct sunlight, allow handset to cool down.
The caller number display function is an optional service offered by telephone network providers. The caller number
appears in the display if the service is offered by your telephone network provider. Contact your network provider for
further information.
The caller has suppressed the transmission of their phone number.
Set the time and date.
Ensure that the answering machine is connected correctly and switched on.
Check whether the answering machine memory is full. Delete the messages.
Check whether the answering machine memory is full. Delete the messages.
Check that the correct PIN has been entered for remote access.
The telephone used for remote access must be set to tone dialling (DTMF).
121