Dmx Connection; Connection Of A Dmx Controller - Renkforce DL-1008 Bedienungsanleitung

• Attach the effect spotlight to a suitable mounting surface or on a suitable crossbeam with the mounting
bracket. The assembly must never swing freely.
• Secure the device with assembly equipment that is compatible with the attachment type and suitable for
carrying the weight of the effect light.
• Additionally secure the installation with a suitable safety restraint cable or a safety net. The safety
retention rope or the net must be designed to support the effect light in the event of failure of the main
support system independently of the main attachment.
• Set the desired inclination angle and tighten the thumb screws well to the assembly bracket.

8. DMX Connection

You can operate a maximum of 32 devices in a DMX chain without overloading the controller.
The maximum total length of the DMX chain should not exceed 500 m.
Use of XLR microphone cables may cause interferences in the DMX signal transmission. In this
case, please use special DMX high-frequency cables.
a) Connection of a DMX Controller
Only connect the device to a DMX controller with a DMX-512 protocol.
• Connect the port DMX IN (2) with the output of the DMX controller.
• The controller must have 6 free control channels.
• Connect DMX OUT (1) with the DMX input of the subsequent device.
• Proceed accordingly with all other devices of the DMX chain.
• If the effect light is the last or the only device in the DMX chain, insert an XLR plug with a
120 ohm/0.25 W terminating resistor into the DMX OUT (1) socket (between Pin2 and Pin3).
25