Display Settings; G) Display Alignment; H) Display Of The Software Version; Handling - Renkforce DL-1008 Bedienungsanleitung

f) Display Settings
• Push the button FUNC (5) until Led is displayed and push the button ENTER (8).
• Use the buttons UP (7) or DOWN (6) to select the desired operating mode:
on: Display permanently on
oFF: The display switches off after the last button is pushed
• Push the ENTER button (8) to confirm the settings.
Pushing the FUNC button (5) switches the display on again temporarily.

g) Display alignment

• Push the FUNC button (5) until dISP or dSIP is displayed and push the ENTER button (8) twice to change
the display alignment.
dISP normal display alignment
dSIP Display alignment turned by 180°

h) Display of the Software Version

• Push the button FUNC (5) until Ver is displayed and push the button ENTER (8).
• The display (3) shows the software version.

11. Handling

• Never connect the mains plug to a mains socket immediately after the device has been taken from a
cold to a warm environment. The resulting condensation may destroy the device. Allow the device to
reach room temperature before connecting it. Wait until the condensation has evaporated.
• Never plug in or unplug the mains plug when your hands are wet.
• Never pull the mains plug from the mains socket by the cable. Only pull it from the mains socket by the
intended grip areas.
• Unplug the mains plug from the mains socket if you are not using the device for an extended period of
time.
• Disconnect the mains plug from the mains socket during thunderstorms for reasons of safety.
• Do not cover the device to ensure sufficient ventilation. Air circulation also must not be impaired by any
objects like magazines, tablecloths, curtains, etc. During operation, keep a minimum distance of 0.5 m
around the device.
30