Dmx Connection; Connection Of A Dmx Controller - Renkforce 1435563 Bedienungsanleitung

• The effect light can be set up or installed with the enclosed holder.
• If you do not want to use the device standing but mount it on a suitable traverse system, attach the effect light with
the included holder and a suitable traverse clamp that is available separately.
• For this, install the holder at the bottom plate with the two bayonet connectors and attach the light effect to the
traverse system with a suitable traverse clamp. Use only assembly material suitable for the type of assembly and
for bearing the effect light load.
• The assembly must never swing freely.
• Additionally secure the installation with a suitable safety restraint cable or a safety net. The safety retention rope or
the net must be designed to support the effect light in the event of failure of the main support system independently
of the main attachment.
• Make sure that the projector head of the light effect spotlight can move freely; it may not hit onto anything or be
blocked.

8. DMX Connection

You can operate a maximum of 32 devices in a DMX chain without overloading the controller.
The maximum total length of the DMX chain should not exceed 500 m.
Use of XLR microphone cables may cause interferences in the DMX signal transmission. In this case,
please use special DMX high-frequency cables.
a) Connection of a DMX controller
Only connect the device to a DMX controller with a DMX-512 protocol.
• Connect the connection DMX IN with the output of the DMX controller.
• The controller must have up to 9 or 15 free control channels depending on the operating mode.
• Connect DMX OUT with the DMX input of the subsequent device.
• Proceed accordingly with all other devices of the DMX chain.
• If the effect light is the last or the only device in the DMX chain, insert an XLR plug with a 120 ohm/0.25 W terminat-
ing resistor into the DMX OUT socket (between Pin2 and Pin3).
26