Dmx Connection; Connection Of A Dmx Controller - Renkforce GM115-25210 Bedienungsanleitung

• Install the light effect on the ceiling, the wall or a suitable crossbeam with the mounting angles. The
assembly must never swing freely. Use assembly material suitable for the assembly area and for bearing
the effect light load.
• Additionally secure the installation with a suitable safety restraint cable or a safety net. The safety reten-
tion rope or the net must be designed to support the effect light in the event of failure of the main support
system independently of the main attachment.
• Set the desired inclination angle and tighten the wing screws to the mounting angles well.

9. DMX Connection

You can operate a maximum of 32 devices in a DMX chain without overloading the controller.
The maximum total length of the DMX chain should not exceed 500 m.
Use of XLR microphone cables may cause interferences in the DMX signal transmission. In this
case, please use special DMX high-frequency cables.
a) Connection of a DMX Controller
Only connect the device to a DMX controller with a DMX-512 protocol.
• Connect the port DMX IN (2) with the output of the DMX controller.
• Use a screened XLR cable for this. The controller must have up to 14 free control channels depending on
DMX mode.
• Connect DMX OUT (3) with the DMX input of the subsequent device.
• If the effect light is the last or the only device in the DMX chain, insert an plug with a 120 ohm/0.25 W
terminating resistor into the DMX OUT (3) socket (between Pin2 and Pin3).
29