Renkforce DL-1008 Bedienungsanleitung Seite 28

Setting the DMX starting address
• Push the button FUNC (5) until Addr is displayed and push the button ENTER (8).
• Select the desired starting address 001-507 with the UP (7) and DOWN (6) buttons.
• Confirm your selection again with ENTER.
The following table provides information about the effects of the settings on the individual DMX channels.
DMX channel Value
1 000
001-199
200-247
248-255
2 000-255
3 000-255
4 000-255
5 000-016
017-032
033-048
049-064
065-080
081-096
097-112
113-128
129-144
145-160
161-176
177-192
193-208
209-224
225-240
241-254
255
6 000-127
128-255
28
Requirement Function
Light off
CH6<128 Brightness of the middle spotlight
CH6<128 Strobe effect middle spotlight slow > fast
CH6<128 Middle spotlight full brightness
CH6<128 Middle spotlight brightness red
CH6<128 Middle spotlight brightness green
CH6<128 Middle spotlight brightness blue
Lateral spotlight automatic programmes 1-15 in sequence
Lateral spotlight automatic programme 1
Lateral spotlight automatic programme 2
Lateral spotlight automatic programme 3
Lateral spotlight automatic programme 4
Lateral spotlight automatic programme 5
Lateral spotlight automatic programme 6
Lateral spotlight automatic programme 7
Lateral spotlight automatic programme 8
Lateral spotlight automatic programme 9
Lateral spotlight automatic programme 10
Lateral spotlight automatic programme 11
Lateral spotlight automatic programme 12
Lateral spotlight automatic programme 13
Lateral spotlight automatic programme 14
Lateral spotlight automatic programme 15
Lateral spotlights off
Channels 2, 3, 4 and 5 activated
Sound-to-Light Mode (Channels 2, 3, 4 and 5 are deactivated)