Automatic Operation; D) Sound-To-Light Mode; Master-Slave Mode - Renkforce DL-1008 Bedienungsanleitung

c) Automatic Operation
• Push the button FUNC (5) until ShNd is displayed and push the button ENTER (8).
• Use the "UP" (7) or "DOWN" (6) buttons to select the desired automatic effect SP01-SP16:
SP01 All automatic effects are switched through in sequence
SP02-SP16 Selection of the individual automatic effects
• Push the ENTER (8) button to confirm the settings.
• Push the button FUNC (5) until SPEd is displayed and push the button ENTER (8).
• Use the "UP" (7) or "DOWN" (6) buttons to select the desired effect speed SP01-SP32:
SP01 slow
SP32 fast
• Push the ENTER (8) button to confirm the settings.
This setting has no effect in sound-to-light operation.

d) Sound-to-Light Mode

• Push the button FUNC (5) until SoUn is displayed and push the button ENTER (8).
• Use the buttons UP (7) or DOWN (6) to select the desired operating mode:
on Sound-to-light mode activated
oFF Sound-to-light mode deactivated
• Push the ENTER (8) button to confirm the settings.
The light effect in sound-to-light operation changes in time to the music.
e) Master-Slave Mode
• Push the button FUNC (5) until SLNd is displayed and push the button ENTER (8).
• Use the buttons UP (7) or DOWN (6) to select the desired operating mode:
NASt Operation as master unit (control via the installed controller)
SLAu Operation as slave unit (control via the controller of the connected master unit)
• Push the ENTER (8) button to confirm the settings.
If the device is to be operated as a single device (standalone), it must be defined as a master
device.
Only one device in a master-slave-chain must be defined as master device. All other devices
must be defined as slave devices.
If the device has accidentally been defined as slave unit in stand-alone operation, the display (3)
shows StbY and the effect light is off.
29