Dmx Connection; Connection Of A Dmx Controller - Renkforce DL-LED163 Bedienungsanleitung

• Install the effect beamer on the ceiling, the wall or a suitable crossbeam with the mounting bracket. The
assembly must never swing freely. Use assembly material suitable for the assembly area and for bearing
the effect light load.
• When set up in an elevated position, secure the device with an additional suitable safety restraint cable
or safety net. The safety retention rope or the net must be designed to support the effect light in the event
of failure of the main support system independently of the main attachment.
• Set the desired inclination angle and tighten the thumb screws well to the assembly bracket.

9. DMX Connection

You can operate a maximum of 32 devices in a DMX chain without overloading the controller.
The maximum total length of the DMX chain should not exceed 500 m.
Use of XLR microphone cables may cause interferences in the DMX signal transmission. In this
case, please use special DMX high-frequency cables.
a) Connection of a DMX Controller
Only connect the device to a DMX controller with a DMX-512 protocol.
• Connect the port DMX IN (2) with the output of the DMX controller.
• Use a screened XLR cable for this. The controller must have 6 free control channels.
• Connect DMX OUT (3) with the DMX input of the subsequent device.
• If the effect light is the last or the only device in the DMX chain, insert an plug with a 120 ohm/0.25 W
terminating resistor into the DMX OUT (3) socket (between Pin2 and Pin3).
Pin assignment of the DMX connection: Pin1 = earth / Pin2 = (-) / Pin3 = (+).
25