Scheppach SC2400p Originalbetriebsanweisung Seite 21

3. Dip the filter (4) in clean engine oil and then
squeeze out all excess oil. The engine will smoke
if too much oil is left in the foam. This can dam-
age the motor after time.
4. Empty the used oil from the air cleaner case (6)
and wash out with nonflammable liquid and dry
the case.
5. Fill the air cleaner case (6) till the oil level mark
(7)with motor oil. Approx. oil capacity: 0,06 l
6. Reassemble the air cleaner in reverse chronol-
ogy.
Important hint in case of sending the equipment
to a service station:
Due to security reasons please see to it that the
equipment is sent back free of oil and gas!
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: Brushes, drive belts, Engine oil, spark
plug, air filter, Elastic cushion, Cut-off snow shield,
wheels
* Not necessarily included in the scope of delivery!
Storage
If the power sweeper will not be used for a period
longer than 30 days, follow the steps below to pre-
pare your unit for storage.
1. Drain the fuel tank completely. Stored fuel con-
taining ethanol or MTBE can start to go stale in
30 days. Stale fuel has high gum content and can
clog the carburetor and restrict fuel flow.
2. Start the engine and allow it to run until it stops.
This ensures that no fuel is left in the carburetor.
Run the engine until it stops. This helps prevent
gum deposits from forming inside the carburetor
and possible engine damage.
3. While the engine is still warm, drain the oil from
the engine. Refill with fresh oil of the grade rec-
ommended in the maintenece plan.
4. Use clean cloths to clean off the outside of the
machine and to keep the air vents free of ob-
structions.
m Do not use strong detergents or petroleum
based cleaners when cleaning plastic parts.
Chemicals can damage plastics.
5. Inspect for any loose or damaged parts. Repair or
replace damaged parts and tighten loose screws,
nuts or bolts.
6. Store your unit on flat ground in a clean, dry build-
ing that has good ventilation.
m Do not store the machine with fuel in a non-
ventilated area where fuel fumes may reach
flame, sparks, pilot lights or any ignition sourc-
es.
21