SensorTherm METIS MF11 Bedienungsanleitung Seite 21

METIS MF11
Introduction
Metis MF Factory settings
Analog output:
Device baud rate:
Emissivity:
Epsilon Slope
Reduction Ratio
Exposition time:
Device address:
Maximum storage:
Subrange limits:
Interface response delay:
Scope of delivery:
Every unit is equipped with optics of your choice, SensorWin software and 2.5 mm hex wrench.
A connecting cable is not included in the delivery and has to be ordered separately (see accessories).
Basic measuring ranges:
600...1300 °C
750...1800 °C
900...2500 °C *
If the unit is equipped with laser pointer for aiming purposes, (Order Number Pos. 13 = 1) the following safety
caution becomes valid:
0-20 mA
19,2 kBd
100% for operation in single wavelength mode
1,000 for operation in dual wavelength mode
5% (refers to 95% signal reduction)
5 ms
00
Storage off
Basic measurement range
00 RS232 and 01 RS485 devices
Metis MF 11
MB 13
MB 18
MB 25 L
The unit is equipped with class 2 laser product!
Do not stare directly into the laser beam radiated by the lens!
Safety advice!
- 21 -