Start up
see Figure 1
Insert the holder for the floor nozzle (option-
al) into the appliance and lock into place.
see Figure 2
Insert the suction hose into the suction
hose connection on the appliance.
Insert the coupling of the fresh water
hose into the fresh water connection of
the appliance and lock into place.
Connect the suction hose to bender of
the manual nozzle.
Connect the coupling of the fresh water
hose to the bender and lock into place.
Selecting the nozzle
Upholstery, wall rugs,
automobile interior
cleaning
Carpeting
Stairs
* not included in the delivery
Operation
see Figure 3
Mix fresh water and detergent in a clean
container (use the concentration rec-
ommended for the detergent).
Warning
Health risk, risk of damage. Observe all in-
dications on the detergent used.
Note
Warm water (max. 50°C) will increase the
cleaning effect.
For considerate treatment of the environ-
ment use detergent economically.
Fill detergent solution into the fresh wa-
ter reservoir. The fill level must not ex-
ceed the "MAX" mark.
Insert dirt water reservoir into the appli-
ance and attach lid.
Plug in the main plug.
see Figure 4
Hand nozzle
Floor nozzle*
Carpet nozzle *
EN
Press the suction switch to turn on the
suction turbine.
Press the spray switch to turn on the de-
tergent pump.
Caution
Risk of damage. Check the object to be
cleaned prior to using the appliance in an
inconspicuous place for colour fastness
and water resistance.
see Figure 5
Use the lever on the bender to spray on
detergent solution.
Run across the surface to be cleaned in
overlapping paths. Pull the nozzle back-
wards (do not push).
see Figure 6
During nozzle changes, the manual
nozzle can be inserted into the holder
for the manual nozzle.
Empty the dirt water reservoir.
If the dirt water reservoir is full, switch
off the suction and spray switches.
Remove the lid.
see Figure 8
Remove the dirt water reservoir from
the appliance and empty it.
Cleaning methods
Normal soiling
Spray and suction off detergent solution
in one work cycle.
Note
A repeated suctioning without spraying will
shorten the drying time.
Strong soiling or stains
Apply detergent solution with suction
turbine turned off and soak for 10 to 15
minutes.
Clean the surface just like with normal
soiling.
In order to further improve the cleaning
result, the surface can be recleaned us-
ing clear, warm water.
– 2
11