Armrest height (fig 7)
1. Loosen the Allen bolt (A) with a 4
mm Allen key.
2. Slide the armrests (B) in the
desired position.
3. Tighten the Allen bolt (A) securely.
Make sure that the arms are
supported well, without the
shoulders being pushed upward.
3.5
Side panel height
Side panel height (fig 7)
1. Loosen the crosshead screws (C)
with a few turns with a Phillips
screwdriver.
2. Slide the side panel (D) in the
desired position.
3. Tighten the crosshead screws (A)
securely.
3.6
Central leg rest
Lower leg length (fig 8)
1. Loosen the Allen bolt (A) by a few
turns using Allen key 5.
2. Adjust the length of the leg rest (B).
3. Tighten the Allen bolt securely.
Ensure that there is sufficient free
space under the footplate for the
wheelchair to drive over obstacles.
Leg rest depth (fig 9)
1. Loosen the Allen bolt (A) by a few
turns using Allen key 6.
2. Slide the leg rest into the desired
position.
3. Tighten the Allen bolt securely.
Adjustment options (for qualified specialist)
Figure 7
Figure 8
Figure 9
A
B
010505010
A
B
010505020
25